TIPP OIL

YOUR SPECIALIST FOR QUALITY LUBRICANTS | MADE IN GERMANY

EMISSION REDUCTION THROUGH REVOLUTIONARY REBOTTLE DEPOSIT SYSTEM

FS PAO CLP 220

FS PAO CLP 220 is made of fully synthetic base Oils and proven additives.

FS PAO CLP 220 product data sheet
FS PAO CLP 220 safety data sheet

Category:

Description

TIPP-OIL FS PAO CLP 220 is made on the Basis of fully-synthetic Oils and proven additives. Due to its special combination of active ingredients of a stable high-pressure absorption capacity in the case of impact is achieved loads. FS PAO CLP 220 provides thanks to its balanced formulation of a stable and protective lubricating film in both extreme Low and high temperatures.

Instructions for use

TIPP-OIL FS PAO CLP 220 can be used in almost all industrial gearboxes that require a synthetic CLP gear oil according to DIN 51517 Part 3. Highly loaded gears can be used at temperatures up to 150 °C reliably lubricated, and the simultaneous corrosion protection, non-ferrous metal-containing components.

specifications

  • AGMA 9005-D94
  • DIN 51517-3

Recommendation

  • Cincinnati Milacron
  • Clean panel coker
  • US Steel 224
  • US Steel S-200

Characteristics

  • Excellent cold behavior
  • Low Pour Point
  • Excellent rust and corrosion protection
  • Very stable high-pressure absorption capacity under shock loads
  • Excellent wear protection
  • Low Foam Formation

Technical specifications

 Properties  Data  unit  testing under
 Kinematic Viscosity at 40°C  221,1  MM²/S  ISO 51562-2
 Kinematic Viscosity at 100°C    30,4  MM²/S  ISO 51562-2
 viscosity index  179  ISO 2909
 Appearance  LIGHT YELLOW  visually
 Density at 15°C  852,0  KG/M³  DIN 51 757
 pour point  -57  °C  ISO 3016

 

All indicated data are approximate values and are subject to the Usual production fluctuations. All information correspond to the best of our Knowledge the current state of findings and our development. Ã"changes remain reserved. All references made to DIN-norms are only for the description of the goods and no warranty is intended. In this Problemfà cases, request technical advice.

Go to Top